AltroFix 19 Plus is your ideal adhesive for use in wet environments, to get great results with your safety flooring. It is a solvent and water-free, two-part polyurethane adhesive that is not affected, once it has cured, by spillages of water and most other liquids. AltroFix 19 Plus is supplied in various handy sized units in the correct quantities for mixing. Both A and B parts are held within the container and need to be mixed before you start. AltroFix 19 Plus can be used with all Altro safety flooring (in areas subject to spillages). Not suitable for use on vertical surfaces. This professional handy-sized 6kg tub has a coverage of approx 24-28m2.
"We used this to fit out new Altro flooring as it is the recommended adhesive from Altro UK. It's really easy to mix and spread and has done the job without any fuss, the different sized tubs available means less waste and better value for money".
Apply adhesive to subfloor only, as soon as possible before adhesive thickens (within 15-20 minutes of mixing, depending on temperature). Spread evenly with a notched trowel. It is important to use a small notched trowel to avoid entrapment of air between the floor covering and subfloor. Place floor covering into wet adhesive, do not roll, and expel all trapped air with the use of a flat wooden or Perspex trowel, wrapped in a soft textile material which has been pre-wetted. Limit trafficking of the floorcovering when the adhesive is still fresh. If any corners, joints or edges are lifting while the adhesive is setting, these must be weighted. Leave weight undisturbed and the floorcovering traffic free until the adhesive has set. Where this procedure is not followed, special care should be taken to check all joints etc, before leaving site for the day.
You do not have any samples in your basket.